Acidic ionic liquid([BsAIm][OTf]) was immobilized on sulfhydryl-group-modified SiO2(MPS-SiO2) via free radical addition reaction. The[BsAIm][OTf] loading on acidic ionic liquid-functionalized silica([BsAIm][OTf]/SiO2) was controlled through tuning the sulfydryl(SH)content of MPS-SiO2. All the samples were characterized by FT-IR, elemental analysis, N2adsorption-desorption measurements and TGDTA. The catalytic performance of [BsAIm][OTf]/SiO2in the esterification of oleic acid and the transesterification of glycerol trioleate for biodiesel production was investigated. The results showed that with the increase of [BsAIm][OTf] loading on SiO2the specific surface area and pore volume of [BsAIm][OTf]/SiO2decreased, and the pore diameter of [BsAIm][OTf]/SiO2narrowed. In the esterificaiton of oleic acid, the oleic acid conversion increased with the increasing [BsAIm][OTf] loading. In the transesterification of glycerol trioleate, with the increasing[BsAIm][OTf] loading the glycerol trioleate conversion decreased and the selectivities to glycerol monooleate and methyl oleate increased.
CeO2-promoted Ni/Al2O3-ZrO2 （Ni/Al2O3-ZrO2-CeO2） catalysts were prepared by a direct sol-gel process with citric acid as gelling agent. The catalysts used for the methane reforming with CO2 was studied by infrared spectroscopy （IR）, thermal gravimetric analysis （TGA）, microscopic analysis, X-ray diffraction （XRD） and temperature-programmed reduction （TPR）. The catalytic performance for CO2 reforming of methane to synthesis gas was investigated in a continuous-flow micro-reactor under atmospheric pressure. TGA, IR, XRD and microscopic analysis show that the catalysts prepared by the direct sol-gel process consist of Ni particles with a nanostructure of around 5 nm and an amorphous-phase composite oxide support. There exists a chemical interaction between metallic Ni particles and supports, which makes metallic Ni well dispersed, highly active and stable. The addition of CeO2 effectively improves the dispersion and the stability of Ni particles of the prepared catalysts, and enhances the adsorption of CO2 on the surface of catalysts. The catalytic tests for methane reforming with CO2 to synthesis gas show that the Ni/Al2O3-ZrO2-CeO2 catalysts show excellent activity and stability compared with the Ni/Al2O3 catalyst. The excellent catalytic activity and stability of the Ni/Al2O3-ZrO2-CeO2 are attributed to the highly, uniformly and stably dispersed small metallic Ni particles, the high reducibility of the Ni oxides and the interaction between metallic Ni particles and the composite oxide supports.
Micro-mesoporous composite molecular sieves H-ZSM-5/MCM-41 were prepared by the hydrothermal technique with alkali-treated H-ZSM-5zeolite as the source and characterized by scanning electron microscopy,transmission electron microscopy,energy dispersive spectroscopy,X-ray diffraction,N2 adsorption-desorption measurement and NH3 temperature-programmed desorption.The catalytic performances for the methanol dehydration to dimethyl ether over H-ZSM-5/MCM-41 were evaluated.Among these catalysts,H-ZSM-5/MCM-41 prepared with NaOH dosage (nNa/nSi) varying from 0.4 to 0.47 presented excellent catalytic activity with more than 80%methanol conversion and 100%dimethyl ether selectivity in a wide temperature range of 170—300℃,and H-ZSM-5/MCM-41 prepared with nNa/nSi=0.47 showed constant methanol conversion of about 88.7%,100% dimethyl ether selectivity and excellent lifetime at 220℃.The excellent catalytic performances were due to the highly active and uniform acidic sites and the hierarchical porosity in the micro-mesoporous composite molecular sieves.The catalytic mechanism of H-ZSM-5/MCM-41 for the methanol dehydration to dimethyl ether process was also discussed.
Yu SangHongxiao LiuShichao HeHansheng LiQingze JiaoQin WuKening Sun
This work provides a general method for preparing monodisperse, water-soluble and paramagnetic magnetic nanoparticles which are easy to be modified. Firstly, magnetic silica with core-shell structure was prepared according to a previous work. Then, the magnetic silica was treated with alkali solution to afford magnetic nanoparticles. With the increase of calcination temperature for the preparation of magnetic silica, the crystallinity and the magnetic responsibility of magnetic silica strengthened, meanwhile, the corresponding magnetic nanoparticles kept monodisperse without any aggregation. The magnetic nanoparticles are comprised of cobalt ferrite and a silica coating. The silica coating on the cobalt ferrite facilitates the magnetic nanoparticles well-dissolved and monodisperse in water, and easilv modified.
