Filter characteristics of a designed gold-filled high birefringence photonic crystal fiber are investigated based on the finite element method. The wavelength filter resonances in the high birefringence photonic crystal fiber occur at different points for different polarized directions, and the resonance strength in the x-polarized case is much weaker than that in the y-polarized case. The much more obvious splitting filter characteristics and different resonance strength imply the study and application values in splitting and single polarization fiber devices. The simulation results show that increasing the number of the gold wires only enhances the resonance strength when there is no surface plasmon supermode formed. With the diameters of the gold wires increasing, the response wavelength moves to a longer wavelength, and the strength becomes stronger. When the diameter is increased to 1.4 μm, the response wavelength in the x-polarized case can be tuned to 1.318 gin, which is the communication wavelength. The strongest resonance occurs at 1.2375 μm in the y-polarized case, and the peaking loss can reach 435.83 dB/cm.
We report supercontinuum （SC） generation in a lead silicate SF57 photonic crystal fiber by using a 1550 nm pump source. The effective nonlinear coefficient of the SF57 fiber is simulated to be 111.5 W-1 .km- 1 at 1550 nm. The fiber also shows ultraflat dispersion from 1700 nm to 2100 nm. Our results reveal that with an increase of the average power of the incident pulse from 10 mW to 90 mW, the SC of the SF57 photonic crystal fiber is generated from 1300 nm to 1900 nm with high stability and without significant change in spectral broadening.
朱星平李曙光杜颖韩颖张闻起阮银兰Heike Ebendorff-HeidepriemShahraam AfsharTanya M. Monro
A simplified structure of birefringent chalcogenide As 2 Se 3 photonic crystal fiber（PCF） is designed.Properties of birefringence,polarization extinction ratio,chromatic dispersion,nonlinear coefficient,and transmission are studied by using the multipole method,the finite-difference beam propagation method,and the adaptive split-step Fourier method.Considering that the zero dispersion wavelength of our proposed fiber is about 4 μm,we have analysed the mechanism of spectral broadening in PCFs with different pitches in detail,with femtosecond pulses at a wavelength of 4 μm as the pump pulses.Especially,mid-infrared broadband polarized supercontinuums are obtained in a 3-cm PCF with an optimal pitch of 2 μm.Their spectral width at 20 dB reaches up to 12 μm.In the birefringent PCF,we find that the supercontinuum generation changes with the pump alignment angle.Research results show that no coupling between eigenpolarization modes are observed at the maximum average power（i.e.,37 mW）,which indicates that the polarization state is well maintained.
This paper presents a theoretical study on a photonic crystal fiber plasmonic refractive index biosensor. The proposed photonic crystal fiber sensor introduces the concept of simultaneous detection with the linearly polarized and radially polarized modes because the sensing performance of the sensor based on both modes is relatively high, which will be useful for selecting the modes to make the detection accurately. The sharp single resonant peaks of the linearly polarized mode and radially polarized mode, are stronger and more sensitive to the variation of analyte refractive index than that of any other polarized mode in this kind of photonic crystal fiber. For linearly polarized mode and radially polarized mode, the maximum sensitivities of 10448.5nm per refractive index unit and 8230.7nm per refractive index unit can be obtained, as well as 949.8 and 791.4 for figure of merits in the sensing range of 1.33-1.45, respectively. Compared with the conventional Au-metalized surface plasmon resonance sensors, our device is better and can be applied as a biosensor.
Kinds of photonic crystal fibers with chalcogenide core tellurite cladding composite microstructure are proposed. The multi-core photonic crystal fiber can reach the higher nonlinearity coefficient and the larger effective mode area. The small single-core photonic crystal fiber has a very high nonlinearity coefficient. At the wavelength λ=0.8μm, the nonlinearity coefficient can reach 31.37053 W-1·m-1, at the wavelength λ=1.55μm, the nonlinearity coefficient is 11.19686W-1·m-1.
We design a novel kind of polarization beam splitter based on a gold-filled dual-core photonic crystal fiber （DC-PCF）. Owing to filling with two gold wires in this DC-PCF, its coupling characteristics can be changed greatly by the second-order surface plasmon polariton （SPP） and the resonant coupling between the surface plasmon modes and the fiber-core guided modes can enhance the directional power transfer in the two fiber-cores. Numerical results by using the finite element method show the extinction ratio at the wavethlengths of 1.327 μm and 1.55 μm can reach -58 dB and -60 dB and the bandwidths as the extinction ratio better than -12 dB are about 54 nm and 47 nm, respectively. Compared with the gold-unfilled DC-PCF, a 1.746-mm-long gold-filled DC-PCF is better applied to the polarization beam splitter in the two communication bands of λ = 1.327 μm and 1.55 μm.
A polarization splitter based on dual-core soft glass photonic crystal fiber （PCF） filled with micron-scale gold wire is proposed. The characteristics of the polarization splitter are studied by changing the structural parameters of the PCF and the diameter of the gold wire with the finite element method （FEM）. The simulation results reveal that the coupling length ratio of the soft glass-based PCF is close to 2 and the corresponding curve is more fiat than that of the silica-based PCE The broadband bandwidth is 226 nm in which the extinction ratio is lower than -20 dB by the soft glass-based PCE i.e., from 1465 nm to 1691 nm which is competitive in the reported polarization splitters, and the bandwidth is just 32 nm by the silica-based PCE The insertion loss by our polarization splitter is just 0.00248 dB and 0.43 dB at the wavelength of 1.47 μm and 1.55 μm. The birefringence is obviously increased and the coupling length is decreased by filling gold wire into the soft glass-based or the silica-based PCE Also the birefringence based on the silica-based PCF is much larger than that based on the soft glass-based PCF whether or not the gold wire is introduced. The fabrication tolerance of the polarization splitter is also considered by changing the structural parameters. The polarization splitter possesses broad bandwidth, low insertion loss, simple structure and high fabrication tolerance.
