A 3D FEM model for symmetric thin-wall tube neck-spinning is established. The spinning process is simulated by means of ANSYS software, and the dynamic boundary and contact problems in simulation are solved. The transient stress distribution of contact area, the transient strain distribution of nodes in typical section and the strain distribution of the whole part at last are attained, and the place and the cause of crack are analyzed. Simulation results show how the strain distribution of typical section, the thickness of some typical nodes, the Z coordinate in typical section and the spinning force of three rollers change with the time. According to study the variation curve, the material flow law along radial, tangential and axial direction is attained and the whole spinning process is studied. The experiment data reflect how the spinning force is influenced by different process parameters, such as feed rate, roundness radius and pass reduction. The simulation and the experiment results supply criteria for optimum design and reasonable parameter selection.
