The phase transformation temperature, segregation behavior of elements and as-cast microstructure were investigated in experimental nickel-base superalloys with different levels of carbon and boron. The results show that the liquidus temperature decreases gradually but the carbide solvus temperature increases obviously with increasing carbon addition. Minor boron addition to the alloy decreases the liquidus temperature, carbide solvus temperature and solidus temperature slightly. Apart from rhenium, the segregation coefficients of the elements alter insignificantly with the addition of carbon. The segregation behavior of rhenium, tungsten and tantalum become more severe with boron addition. The volume fraction and size of primary carbides increase with increasing carbon addition. The main morphology of the carbides is script-like in the alloys with carbon addition while the carbide sheets tend to be concentrated and coarse in the boron-containing alloys
The influence of melt convection on dendrite growth during the upward-directional solidification of Pb-33%Sn binary alloys was investigated.The melt convection was modulated by traveling magnetic field.When the direction of traveling magnetic field was changed from upward to downward,the primary dendrite spacing gradually increased,and the distribution peak of the primary dendrite spacing shifted to the field of narrower spacing.These result from the different intensities of melt convection,which are controlled by the traveling magnetic field.The effects of the traveling magnetic field on melt convection are similar to those of adjustment in the gravity level,thus,the primary dendrite spacing varies.When the intensity of the traveling magnetic field was 1 mT,and the drawing speed was 50 μm/s,the gravity acceleration reached 0.22g for the downward-traveling magnetic field and 3.07g for the upward-traveling magnetic field.
The properties of Ni-base superalloy castings microstructure, and different solidification methods have are closely related to the uniformity of their as-cast serious effect on microstructural uniformity. In this paper, the influences of high rate solidification （HRS） process （with or without superheating） and liquid metal cooling （LMC） process on the microstructure of DZ125 superalloy were investigated. Blade-shape castings were solidified at rates of 40 pm.s-1 to 110 tJm.s1 using HRS process and a comparative experiment was carried out at a rate of 70 IJm.s1 by LMC process. The optical microscope （OM）, scanning electron microscope （SEM） were used to observe the microstructure and the grain size was analyzed using electron back scattered diffraction （EBSD） technique. Results show that for the castings by either HRS or LMC process, the primary dendrite arm spacing and size of 7＇ precipitates decrease with increasing the withdrawal rate; the dendrites and 7＇ precipitates at the upper section of the blade are coarser than those in the middle, especially for the HRS castings without high superheating technique. When the withdrawal rate is 70 iJm.s1, the castings by HRS with high superheating technique have the smallest PDAS with fine 7＇ precipitates; while the size distribution of 7＇ precipitates is more homogenous in LMC castings, and the number of larger grains in LMC castings is smaller than that in the HRS castings. Moreover, high superheating technique yields smaller grains in the castings. Both the LMC method and HRS with high superheating technique can be used to prepare castings with reduced maximum grain size.
Ge BingmingLiu LinZhang JunLi YafengFu HengzhiLiu Xiaofu
