The pressure profiles, gas velocities, solid circulation rate, solids flux, residence time distribution of gas and particles in chemical-looping combustion reactors and gas leakage were studied in a cold flow model unit. And these parameters in both air and fuel reactors were measured in the experimental stage. The experimental results show that gas fluidization velocity in the air reactor is 1.8 m/s, gas fluidization velocity in the fuel reactor 0.5 m/s, and the bed materials inventory of the two reactors between 1.2 to 3.15 kg. The first cold flow model results show that the solid circulation rates are sufficient. The appropriate operating conditions are optimized and the summary of final changes is made the on cold model. The proposed design solutions are currently being verified in a cold flow model simulating the actual reactor(hot) system. This paper presents an overview of the research performed on a cold flow model and highlights the current status of the technology.
Abstract:The aim of this research is to design and operate a 10 kW hot chemical-looping gasification(CLG)unit using Fe2O3/Al2O3as an oxygen carrier and saw dust as a fuel.The effect of the operation temperature on gas composition in the air reactor and the fuel reactor,and the carbon conversion of biomass to CO2and CO in the fuel reactor have been experimentally studied.A total60 h run has been obtained with the same batch of oxygen carrier of iron oxide supported with alumina.The results show that CO and H2concentrations are increased with increasing temperature in the fuel reactor.It is also found that with increasing fuel reactor temperature,both the amount of residual char in the fuel reactor and CO2concentration of the exit gas from the air reactor are degreased.Carbon conversion rate and gasification efficiency are increased by increasing temperature and H2production at 870℃reaches the highest rate.Scanning electron microscopy(SEM),X-ray diffraction(XRD)and BET-surface area tests have been used to characterize fresh and reacted oxygen carrier particles.The results display that the oxygen carrier activity is not declined and the specific surface area of the oxygen carrier particles is not decreased significantly.
