The conventional rare earth solvent extraction equipments have many problems such as long mixing time, low processing capacity, large factory area occupation, high energy consumption and so on. In order to solve the problems, many types of equipments were brought out. In this work, studies were carried out on the La（III） extraction process with 2-ethylhexyl phosphoric acid-2-ethylhexyl ester （EHEHPA） by membrane dispersion micro-extractor. Equilibrium studies showed that the initial aqueous pH value 4.15 with the saponification rate 40%was the optimal operation condition. The effects of membrane dispersion micro-extractor operational conditions such as dispersion mode, bulk flow rate and organic phase flow rate on the extraction efficiency were studied. The results showed that when the organic solution was the dispersed phase, the extraction efficiency was higher than that of others. Increasing bulk flow ratio could enhance the extraction efficiency greatly. When the ratio of organic phase flow rate to that of aque-ous phase was 80：80, the extraction efficiency was over 95%. The effect of stripping phase acidity on the La（III） recovery was studied. The results showed that when the stripping phase pH was 2.0, organic phase flow rate to stripping phase flow rate was 20：80;the re-covery efficiency of La（III） can reach 82%.
The feasibility of emploving non-ionic surfactant （Triton X-100） as an alternative and effective solventfor the microwave-assisted extraction of glycyrrhizic acid （GA） and liquiritin （LQ） from licorice root was studied.The optimal extraction parameters based on the microwave-assisted micellar extraction technique were determined.Under the optimal conditions, i.e. 5% （by volume） Triton X-100, microwave-assisted extraction for 3--5min at 373K, the percentage extraction of active ingredients reached the highest value. The preconcentration tactor for GA and L＇Q （about 13.5） and the extraction efficiency for these two ingredients approached 100% showed the coupling of microwave-assisted extraction and cloud-point extraction could be employed as a new and. effective techniquefor the rapid extraction and preconcentration of pharrnacologically active ingredients from medicinal plants SUCh aslicorice root without disturbing chromatographic analysis.
This paper presents the experimental investigations of the emissions of SO2, NO and N20 in a bench scale circulating fluidized bed combustor for coal combustion and co-firing coal and biomass. The thermal capacity of the combustor is 30 kW. The setup is electrically heated during startup. The infuence of the excess air, the degree of the air staging, the biomass share and the feeding position of the fuels on the emissions of SO2, NO and N2O were studied. The results showed that an increase in the biomass shares resulted in an increase of the CO concentration in the flue gas, probably due to the high volatile content of the biomass. In co-firing, the emission of SO2 increased with increasing biomass share slightly, however, non-linear increase relationship between SO2 emission and fuel sulfur content was observed. Air staging significantly decreased the NO emission without raising the SO2 level. Although the change of the fuel feeding position from riser to downer resulted in a decrease in the NO emission level, no obvious change was observed for the SO2 level. Taking the coal feeding position R as a reference, the relative NO emission could significantly decrease during co-firing coal and biomass when feeding fuel at position D and keeping the first stage stoichiometry greater than 0.95. The possible mechanisms of the sulfur and nitrogen chemistry at these conditions were discussed and the ways of simultaneous reduction of SO2, NO and N2O were proposed.
