A fiber Bragg grating strain sensor,whose reflection bandwidth is insensitive to temperature,is presented.The cross-sec-tional area is designed to change linearly.Under axial stress,there is a linear relationship between stress and average strain.Experimental results show that when temperature increases,reflection center wavelength shifts to longer wavelength,and there is a good linear relationship between center wavelength and temperature.When stress increases,reflection center wavelength shifts to longer wavelength,and reflection bandwidth increases.There are good linear relationships between reflection center wavelength and stress as well as reflection bandwidth and stress.
A new method is presented to tune Bragg wavelength slightly by using hydrofluoric acid to etch fiber cladding.The spectral characteristics before and after etching and the change properties of Bragg wavelength are studied.Cladding modes are reduced during the etching process.High-order cladding modes are converted into radiation modes,and energy of cladding modes is coupled to the outside.As the cladding radius decreases,the Bragg wavelength shifts to longer direction.Experimental results show that this method can tune Bragg wavelength slightly,and the tunable range is 0.002-0.120 nm.
Optical waveguide is used to guide the transmission of light. This paper reviews multilayer optical waveguide and some devices based on it. The optical waveguide can be divided into single-layer and multilayer optical waveguides in general. Here, multilayer cylindrical waveguide and multilayer planar waveguides were mainly focused. The analyzing method and the structures of waveguides were also demonstrated in briefly. Both these multilayer optical waveguide used in different kinds of optical devices including optical modulator, laser, optical amplifier, optical switch and special fiber were further presented. At last, the principle and structure of these multilayer optical devices were compared.
Sijun WENG, Li PEI Li PEI Ruifeng ZHAO Junjie YANG Yiqun WANG
In this paper, several photonic generating methods for optical triangular pulses were reviewed. Four frontier research methods for generating optical triangular pulses were introduced, these four methods are respectively based on the frequency-to-time conversion, using normally dispersive fiber, by single-stage dual-drive Mach-Zehnder modulator （MZM）, and using dual-parallel MZM. These four methods can be classified into two categories in terms of the optical source employed, such as mode-lock laser （MLL） and continuous-wave （CW） respectively. Compared with the methods based on MLL, those based on CW have many advantages, such as simpler structure, lower price, higher stability, more flexible and wider tunability. Besides, the method using single-stage drive MZM can generate versatile waveform optical pulses, which has better performance than the first two methods in tunable capability of both repetition rate and center wavelength. With the same driving signal applied, the optical source using the dual-parallel MZM can generate signal with higher frequency than that of using the single-stage MZM.
